Whipple Supercharger Upgrade "tuner" Kit for 2005-2006 Ford GT (Polished)
GT SC UPGRADE
your craving more power from your GT Supercar, Whipple has the answer. Get the
industries largest, most efficient and latest designed twin-screw supercharger
available today. The new Whipple system can produce incredible power levels
with stock 5.4L GT engines as well as highly modified engines. The revolutionary
new W210ax compressor has the ability to run nearly 30lbs of boost (engine modifications
required) for unheralded performance.
direct bolt-on replacement system gives you the ability to run far higher boost
levels than the factory 2.3 liter screw-type supercharger while lowering supercharger
air temperatures and power consumption (hp). This bolt-on system comes as a
“tuner” system which gives tuners the ability to run various boost
levels and tunes.
to run a different boost level? In a matter of minutes, just loosen the 4 bolts,
release tension from belt and the SC pulley can be replaced. No need to remove
the supercharger for every pulley change as you must with the factory SC. Each
kit includes two SC pulleys of your choice, an adjustable idler pulley for extra
belt wrap on the sc pulley and extra belt adjustment as well as all the necessary
hardware for a very easy bolt-on installation. Whipple also offers a custom-tuned
Diablo Predator flash tool and Diablo MAFia for direct bolt-on performance.
Whipple GT kit not only offers a better supercharger, but the potential to have
one of the fastest, most powerful street machines on the road today.
INSTANT BOOST / HORSEPOWER & TORQUE AT ANY RPM
- Over 100rwhp
gain with 15psi and custom tune
- Over 200rwhp
gain with 19psi, custom tune, Ford Racing headers and cat-back exhaust
- Over 40hp
gain at stock boost levels due to lower parasitic losses
- Over 40deg
F cooler air at 15psi allows for more spark advance and more power
- Direct bolt
- Lower noise
- More power,
cooler charge air temp, less power consumption/parasitic loss than stock
Lysholm 2.3 liter
- 3.4 liter
vs. 2.3 liter compressor for more power potential
- Up to 95%
- Boost range
15 - 30 psi with SC pulley changes
- 4 bolts to
remove SC pulley, no need to pull SC off for pulley
- Included adjustable
idler pulley for extra belt adjustment
- Award winning
fit and finish
- Polished finish
Air Flow Sensor:
Factory MAF will peg at 16-17psi depending on environment. Whipple recommends
running the Diablo MAFia to extend the MAF sensor range. Custom PCM calibration
is required to utilize this piece.
The factory rubber air inlet needs to be supported on any boost level over 15psi.
When airflow levels go past this, the factory rubber inlet will collapse. Whipple
offers a plastic insert that will help support the rubber inlet.
Whipple recommends running a larger Throttle Body if you run boost levels that
are over 19psi.